Month: July 2024

A control mechanism used to operate a mechanical ventilation system based upon the relative humidity…

Coped joint is to Cutting and fitting woodwork to an irregular surface.

Removing the top and bottom flange of the end of a metal I-beam. This is…

The cooling load is the amount of heat energy that would need to be removed…

Contour lines connect a series of points of equal elevation and are used to illustrate…

A device that tells whether a circuit is capable of carrying electricity.

Densification of soil by mechanical equipment such as jumping jacks, plate compactors, etc.

A circuit where electricity flows in one direction only, at a constant rate.

Work the framing contractor does after the mechanical subcontractors finish their phase of work at…

An axial compressor is a machine that can continuously pressurise gases. It is a rotating,…

A member used as a joist substitute which is intended for use at very short…

It is used for lintels or headers over a door or window which support masonry…

A vertical member supporting a wall system designed to withstand horizontal wind loads. Usually between…

A drawing or diagram which shows the outline of a joist with dimensions and also…

It is a wheel on an axle or shaft that is designed to support movement…